diff --git a/files/kamp/Adaptive_Meshing.cfg b/files/kamp/Adaptive_Meshing.cfg
index 40aab8b..65f6d82 100644
--- a/files/kamp/Adaptive_Meshing.cfg
+++ b/files/kamp/Adaptive_Meshing.cfg
@@ -72,4 +72,5 @@ gcode:
             G4 P5000
         {% endif %}
     {% endif %}
-    _BED_MESH_CALIBRATE mesh_min={adapted_x_min},{adapted_y_min} mesh_max={adapted_x_max},{adapted_y_max} ALGORITHM={algorithm} PROBE_COUNT={points_x},{points_y}
+    {% set profile_param = "PROFILE=" ~ params.PROFILE if params.PROFILE is defined else "" %}
+    _BED_MESH_CALIBRATE mesh_min={adapted_x_min},{adapted_y_min} mesh_max={adapted_x_max},{adapted_y_max} ALGORITHM={algorithm} PROBE_COUNT={points_x},{points_y} {profile_param}
diff --git a/files/kamp/Start_Print-3v3.cfg b/files/kamp/Start_Print-3v3.cfg
index 5fee47f..16c81f6 100644
--- a/files/kamp/Start_Print-3v3.cfg
+++ b/files/kamp/Start_Print-3v3.cfg
@@ -105,7 +105,7 @@ gcode:
     {% if printer['output_pin ADAPTIVE_BED_MESH'].value == 1 %}
       RESPOND TYPE=command MSG="Starting Adaptative Bed Mesh..."
       BED_MESH_CLEAR
-      BED_MESH_CALIBRATE
+      BED_MESH_CALIBRATE PROFILE=adaptive
       BED_MESH_PROFILE SAVE=adaptive
       BED_MESH_PROFILE LOAD=adaptive
     {% else %}
diff --git a/files/kamp/Start_Print.cfg b/files/kamp/Start_Print.cfg
index f2a6d92..de93442 100644
--- a/files/kamp/Start_Print.cfg
+++ b/files/kamp/Start_Print.cfg
@@ -100,7 +100,7 @@ gcode:
     {% if printer['output_pin ADAPTIVE_BED_MESH'].value == 1 %}
       RESPOND TYPE=command MSG="Starting Adaptive Bed Mesh..."
       BED_MESH_CLEAR
-      BED_MESH_CALIBRATE
+      BED_MESH_CALIBRATE PROFILE=adaptive
       BED_MESH_PROFILE SAVE=adaptive
       BED_MESH_PROFILE LOAD=adaptive
     {% else %}