add doc for lunarbot remote control

docs/LunarRover/Remote Control.md

@@ -0,0 +1,59 @@
+---
+last_update:
+  date: 10/25/2024
+  author: CabbageDog
+---
+
+# Remote Control
+
+With all hardware assembly, software installation and LAN setup, you can control the entire LunarBot with XBOX 360 joystick. 
+
+## STEP BY STEP
+1. Turn on two 24V batteries, robotic arm and chassis.
+2. Connect your device to WIFI: REDMI with PASSWORD: dssl123456. 
+3. Launch **TEAMVIEWER** app, connect to the LunarBot by ip: 192.168.1.145, password: dssl62794316.
+4. Turn on XBOX360 joy stick. it should indicate **connected to receiver 1**. 
+4. **WITH IN** the remote desktop of the LunarBot, run following commands
+```bash
+# Terminal 1
+sudo xboxdrv --silent
+
+# IT MUST SAYS CONNECTED WITHOUT ANY ERROR, 
+#   IF USB UNCONNECTED, RE-PLUG THE RECEIVER AND RUN AGAIN
+#   IF NO XBOX CONTROLLER CONNECTED, RE_PLUG RECEIVER WHILE RESTART THE JOYSTICK, THEN RUN AGAIN
+```
+```bash
+# Terminal 2
+cd Lunar_Rover_Hardware_Ws
+. ./install/setup.bash
+ros2 launch vos_bringup vos_bringup.launch
+
+# IT MUSH SAYS VOS_CONTROLLER IS ACTIVE, IF NOT:
+#   RESTART LUNARBOT
+#   RESTART MINI PC
+```
+
+```bash
+# Terminal 3
+cd Lunar_Rover_Hardware_Ws
+. ./install/setup.bash
+ros2 launch rm_bringup rm_75_bringup.launch.py
+```
+
+```bash
+# Terminal 4
+cd Lunar_Rover_Hardware_Ws
+. ./install/setup.bash
+ros2 launch lunar_rover_remote remote.launch.py
+```
+
+6. GOOD TO GO. **PRESS BUTTON B** then stick for chassis and only stick for arm.
+
+## TROUBLESHOOTING
+
+### Config the Correct Device ID of the Joystick
+In `lunar_rover_remote` package, all launch file starting `joy_node` should be assigned with correct device ID. 
+
+**Different USB PORT that Receiver of Joystick** may lead to different device id. 
+
+If you found that it's not working when all scripts above is running correctly, check this.